top of page
kat_gross DESIGN
step by step
process to the
TETRIS RACK
1/2
STEP 1
At the beginning I sawed all pieces on 45° mitre-cut and glued them together.
UTENSILS
filler, putty knife, hammer, abrasice sponge, hand brush
UTENSILS
sandpaper in different grain sizes
UTENSILS
dust mask and chisel
UTENSILS
putty knife with filler on it
STEP 2
Afterwards I filled the holes on the cut surface of the chip board.
STEP 3
Waiting for the filler to dry.
STEP 4
Then I had to sand it down to get a smooth surface.
STEP 5
Finally I painted the pieces, five of them are white outside and blue inside but one piece is in reverse.
FIRST TRY OUT
There are numerous ways to arrange the different modules.
FINALE
Sideview of the end arrangement of the tetris rack, in this case it was used as decorative shoe storage.
© Katharina Gross. All rights reserved
bottom of page